The Deformation Probe supports a non-default choice of Remote Points as location for the measurement of deformation. Workbench Mechanical has a Deformation Probe object for postprocessing. If there is no load on the remote point, movement is measured without affecting the result.Īs an alternative, users could employ a General Body-Ground joint attached to the face of interest, free all degrees of freedom, and use a Joint Probe to measure Relative Rotation This avoids APDL commands.
If the remote point interacts with a face that is set to Deformable, an averaged value of face movement is measured.
How to get imprint faces option in ansys 15 workbench how to#
This article illustrates how to use APDL commands to refer to an existing Remote Point, and measure translation and rotation at the point. Industrial Equipment and Rotating MachineryĪnsys Mechanical Workbench supports Deformation Probes, which on solid bodies can measure UX, UY, UZ and USUM of geometry or Remote Points.Torsional Vibration Measurements Testing.Structural & Thermal Applications (FEA).Particle Simulation Applications (Rocky DEM).Forensic Engineering & Expert Witnesses.Fluid Flow & Thermal Applications (CFD).Electronic and Electrical Applications (EM).